輸出脈沖寬度和頻率由外部觸發源控制。
有兩種型號可供選擇：PVM-1001-P 產生正電壓脈沖，需要外部正高壓電源;PVM-1001-N 產生負脈沖，需要負電源。
前面板有一個用于觸發輸入的 SMB 連接器和一個用于交流/直流適配器的連接器。后面板配有 MHV 連接器，用于高壓輸入和脈沖高壓輸出。
規格參數
| PVM-1001 Positive | |
| Input HVPS Requirements | |
| HV Input Voltage | ≤ 975 VDC Positive Source |
| HV Input Power | > Output Power + 5 W |
| Pulse Amplitude | |
| Output Voltage Range | 0V to +950V |
| Output Droop | < 10 V/µs |
| Voltage Overshoot | ≤ 10% (900V to 950V) ≤ 12% (700V to 899V) ≤ 14% (400V to 699V) ≤ 15% (100V to 399V) ≤ 17% (50V to 99V) |
| Rise Time | ≤ 8 ns @ 200 V to 950 V ≤ 10 ns @ 50 V to 199 V |
| Fall time | ≤ 50 ns @ 450 V to 950 V ≤ 80 ns @ 200 V to 449 V ≤ 130 ns @ 50 V to 199 V |
| Polarity | Positive |
| Compliance Voltage | 25 V above desired output voltage |
| Maximum Output Power | 208 W Refer to SOA Graphs |
| PVM-1001 Negative | |
| Input HVPS Requirements | |
| HV Input Voltage | ≤ -975 VDC Negative Source |
| HV Input Power | > Output Power + 5 W |
| Pulse Amplitude | |
| Output Voltage Range | 0 V to -950 V |
| Output Droop | < ?10 V/µs |
| Voltage Overshoot | < 10 % ?800 V to ?950 V < 12 % ?150 V to ?799 V < 20 % ?50 V to ?149 V |
| Fall Time | ≤ 9 ns @ ?500 V to ?950 V ≤ 10 ns @ ?200 V to ?499 V ≤ 12 ns @ ?50 V to ?199 V |
| Rise time | ≤ 50 ns @ ?450 V to ?950 V ≤ 80 ns @ ?200 V to ?449 V ≤ 130 ns @ ?50 V to ?199 V |
| Polarity | Negative |
| Compliance Voltage | ?25 V above desired output voltag |
| Maximum Output Power | 208 W Refer to SOA Graphs |
| PVM-1001 Positive & Negative | |
| External Trigger Requirements | |
| Frequency Range | ≤ 1 MHz |
| Burst Mode | ≤ 5 MHz |
| Trigger pulse width | 55 ns ≤ Pulse width ≤ 10,000 ns |
| Delay (input trigger to output) | ≤ 75 ns |
| Termination Impedance | 50 Ω |
| Connector | SMB |
| Voltage Levels | 0 V, output off (open) 5 V, output on (high voltage) |
| Power Specifications | |
| DC Power Source | 12 VDC, 12 W, supplied by adapter (included) |
| Adapter Power Requirements | 100 VAC to 240 VAC |
| Output Connector | |
| Output Connector | MHV, Rear Panel |
| General | |
| Size (HxWxD) | 6.5 cm x 20.4 cm x 10 cm |
| Weight | 0.5 kg |
| Operating Temperature | 15 °C to 40 °C |
備注
PVM-1001 電壓源符合或超出這些規格。
這些規格是在驅動 50 歐姆負載(Bird Electronics，1500W，50 歐姆，型號 8860)并連接 3 英尺 RG-58 同軸電纜的情況下測得的。
960 V 正輸出脈沖，輸入 50 Ω 負載
960 V 負輸出脈沖，輸入 50 Ω 負載
969 V 正輸出 5 MHz 突發脈沖，輸入 50 Ω 負載 負型號具有相同的突發脈沖能力
最大占空比與輸出電壓的關系
最大頻率與輸出電壓的關系
最大脈沖寬度與輸出電壓的關系
關于我們
深圳市博納德精密儀器有限公司是一家進口儀器渠道商，代理的產品有：Femto放大器、激光功率計、光束分析儀、光束收集器、光斑分析儀、高功率連續變焦光纖激光器準直頭FAC、德國GTE、德國hhb Electronic、Pacific Lasertec氦氖激光器、SRS斯坦福放大器、Scitec光學斬波器、AA Lab Systems設備、DL Instruments放大器、摩擦系數檢測、IP1x-6x防塵試驗指、IPX1-X8防水試驗設備等其它專業設備，如有需求可以聯系咨詢我們。
點擊交流